You will get this from the admins of the corresponding data project in SeviRe to which your s3-bucket belongs.ĭownload WinSCP and run the installation program:įor the installation you need admin rights.Īlternatively, you can download the portable version, which you can use without installing and thus without admin rights. We will work with the portable version in this tutorial. Immediately after startup, an input window will open, allowing you to configure a new connection.

Select 'Amazon S3' in the 'File protocol' field and copy the values listed in the table below into the respective fields of the input mask. There are a total of five input fields to fill in - please refer to the resource configuration in Coscine or RWTH Publications for the corresponding values. In the case of RWTH Publications, you will find the document 'Datenzugang_DataAccess.pdf' for your data set.

Note that the Host name field in WinSCP corresponds to the Entry point field in Coscine. If you copy the value, you should paste it without prefix and without port postfix in WinSCP, otherwise an incorrect redirection will be made. For simplicity, you should copy the host name value given below. Now click 'Login' to connect to the resource. You can save the connection configuration beforehand for later reuse by clicking on the 'Save' button. This is recommended so that you do not have to re-enter the above data over and over again. If you are prompted with a certificate error, you are probably using an outdated version of the WinSCP client.

Compare the version you are using with the version on the download page given in section 1 and update if necessary.

Cyberduck s3